MIDEA Top Load Impeller - Manual (Page 41)

Problem Solutions
Washer does
not drain or
spin
The water
temperature
is not correct
Check the fuse or reset the circuit breaker.
Close the lid, then press the
Start Pause button to start
your washer. For your safety, your washer does not spin
unless the lid is closed.
Make sure that the drain hose is not kinked. Straighten
as necessary.
Make sure that the height of the drain hose is within
specified limits. See
Drainage requirements on page 14.
The pipes to your sewer system may be clogged.
Contact a plumber or qualified repair professional.
•
•
•
•
•
Make sure that you have selected the correct temp.
Make sure that the water source faucets are fully
opened.
Make sure that the hoses are connected to the correct
faucet and water intake connections on your washer,
then flush the lines. See
Connect the water hoses on
page 19.
Disconnect the hoses and clean the screens. The hose
filter screens may be clogged.
•
•
•
•
•
•
Load is too
wet at the end
of the cycle Use a high-efficiency detergent to reduce over-sudsing
See
Selecting a detergent on page 30.
The load may be too small. Very small loads (one or
two items)may become unbalanced and not spin out
completely.
Water leaks Make sure that all hose connections are tight. See
Connect the water hoses on page 19 and Connect the
drain hose on page 21.
Make sure that the end of the drain hose is correctly
inserted and secured to the drainage system. See
Connect the drain hose on page 21.
Avoid overloading.
Use a high-efficiency detergent to reduce over-sudsing.
See
Selecting a detergent on page 30.
•
•
•
•
Oversuds
condition Use a high-efficiency detergent to reduce over-sudsing.
See
Selecting a detergent on page 30.
If you have"soft" water, reduce the amount of detergent.
For small or lightly soiled loads, reduce the amount of
detergent.
•
•
•
41
Safety
Instructions
Features
Operation
Requirements
Installation Instructions
Washer Use
Washer Care
Tro
ub
le
sh
oo
tin
g