MIDEA Top Load Impeller - Manual (Page 21)

Connect the drain hose
Caution
5.
•
•
Do not overtighten the fittings or apply tape or sealant to the faucets
or water supply intakes. This can damage the fittings.
Make sure that the water supply hoses are not twisted or bent. A bent
or twisted hose can leak and cause an electric shock due to the water
leakage. To ensure the correct water usage, connect both hot and
cold water faucets. lf either or both are not connected, an error code
could occur.
Tighten the fittings by hand until they are snug, and then tighten them
an additional two-thirds of a turn with a pliers.
6. Turn on the hot and cold water supplies and check all the water supply
intake connections and the faucets for water leaks.
1. Find the end of the drain hose that has the clamp, then slide the clamp
away from the end of the hose.
Caution
Failure to slide the drain hose completely over the washer’s drain pipe
may result in water leakage.
Failure to move the clamp or hoop onto the washer’s drain pipe will
result in water leakage.
21
•
•
Safety
Instructions
Features
Operation
Requirements
Installation Instructions
Washer Use
Washer Care
Tro
ub
le
sh
oo
tin
g