Roborock Dyad Pro FCC - Manual (Page 16)

17
Routine Maintenance
Parts
Maintenance
Frequency
Replacement
Frequency
Roller 2–4 weeks 6–12 months
Filter 1 month 6–12 months
Cleaning head and
dirty water pipe
1 month N/A
Dirty tank 1 month N/A
Dirty water level
sensor
1 month N/A
Charging dock tray As needed N/A
Charging contact 1 month N/A
To maintain optimal performance of the product, refer to the
following table for routine maintenance.
Product Maintenance
1. Take out the dirty tank, pull out the cover, and open the water
level sensors. Clean the parts with the provided maintenance
brush, rinse them with cold water, and then snap the water
level sensors back in place.
Wipe and clean the body with a soft and dry cloth. Before cleaning,
unplug the power supply and keep the vacuum cleaner off.
Cleaning the Body
Cleaning the Dirty Tank and Filter
If this product is left unused for a prolonged period of time,
fully charge it and unplug it before storing it in a cool and dry
place. Do not place the product in humid locations or under
direct sunlight. Charge it at least once every 3 months to avoid
overdischarge.
Water Level Sensors
2. Take out the filter from dirty water tank cover and remove any
trash attached to the filter. If the filter is dirty, rinse it with cold
water and then shake off the residual water.