Roborock Dyad Pro FCC - Manual (Page 13)

14
You can modify the settings in the app to enable automatically resume operation after
unlocking the cleaning head.
Press the change mode button to switch between AUTO, MAX,
Floor Drying and ECO modes. The screen will display the icon for
the current mode.
Switching Modes
Notes:
• Floor Drying mode is for removing clean water from wet environments such as bathrooms.
It should not be used when water depth exceeds 10mm (0.4in).
• Floor Drying mode is limited to one minute. After which, AUTO mode will resume.
You can adjust the splash guard using the lift toggle. You can
raise it to collect large pieces of waste on the floor and lower it
to prevent the cleaning head from getting stuck when there are
many objects on the floor.
1. When the vacuum cleaner is operating, press the power button
to pause it and enter standby mode.
2. In standby mode, you can lock the cleaning head and place the
vacuum cleaner upright on the floor.
3. Lock the cleaning head and press and hold the power button
for 2 seconds to turn off the vacuum cleaner. If the vacuum
cleaner is left idle for 5 minutes in standby mode, it will
automatically turn off.
Adjusting the Splash Guard
Standby and Power Off
Instructions for Use
Note:
ECO Mode
AUTO Mode
Floor Drying Mode
MAX Mode
Press: Switch to AUTO/MAX/
Floor Drying/ECO mode
Change Mode