Roborock S8 Pro Ultra CE - Manual (Page 8)

08
❷ Reset WiFi
1. Open the top cover and find the WiFi
indicator.
2. Press and hold the and buttons until
you hear the “Resetting WiFi” voice alert.
The reset is complete when the WiFi
indicator flashes slowly. The robot will
then wait for a connection.
If you cannot connect to the robot due to your router
configuration, a forgotten password, or any other reason,
reset the WiFi and add your robot as a new device.
Note:
Open the Roborock App, tap the “Scan to
Connect” button or the “Search for
device” button, or open the Xiaomi Home
app, tap “+” in the top right corner and add
the device as instructed in the app.
Notes:
• The actual process may vary due to ongoing app updates.
Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the robot waits more than 30 minutes for a connection,
WiFi will be automatically disabled. If you want to reconnect,
reset the WiFi before proceeding.
❸ Add device
Instructions
Notes:
• To prevent corrosion or damage, only use the Roborock
branded floor cleaner in the water tank.
• To avoid water tank deformation, do not place hot water
in the tank.
• If water marks remain on the water tank, wipe them clean
before reinstallation.
Filling the Clean Water Tank
Open the clean water tank and fill the tank
with water. Close the lid, lock the latch, and
fit the tank back in place.
Note: The robot cannot be turned off when it is being
charged.
Press and hold the button to turn on the
robot. The power indicator will turn on and
the robot will enter standby mode. Press
and hold the button to turn off the robot
and complete the cleaning cycle.
On/Off
Press the button to start cleaning. The
robot will plan its cleaning route according
to its scan of the room. It splits a room
into zones, first draws out zone edges, and
then fills the zone in a zigzag pattern. In
so doing, the robot cleans all zones one by
one, efficiently cleaning the house.
Starting Cleaning
Zone 1 – Cleaned
Zone 4 – Next Zone
Zone 2 – Cleaned
Zone 3 – In Progress
Notes:
• To allow the robot to automatically vacuum and return to
the dock, start the robot from the dock. Do not move the
dock during cleaning.
• Cleaning cannot start if the battery level is too low. Allow the
robot to charge before starting the cleanup.
• If cleaning is completed in less than 10 minutes, the area
will be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left off.
• When the mop mount is attached, the robot will retract it
when cleaning the carpet. You can also set the carpet as a
no-go zone in the app to avoid it.
• Before starting each mopping task, make sure that the
VibraRise mop has been properly installed.
Note: After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
Press and hold and buttons
simultaneously to start spot cleaning. The
robot cleans a 1.5 m (4.9 ft) x 1.5 m (4.9 ft)
square area centered on itself.
Spot Cleaning