Roborock S8 Pro Ultra CE - Manual (Page 11)

11
Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
Purchase an additional filter and alternate if necessary. Note:
C6-3—
C6-2—
Remove the VibraRise mop cloth from
the VibraRise mop mount. Clean the
VibraRise mop cloth and air-dry it.
C7-1—
* Clean as required and replace every 3-6 months.
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Battery
The robot is equipped with a built-in high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Open the filter cover and remove
the filter.
C6
Washable Filter
Remove the water tanks and the dustbin
before moving the dock. Grip the handle on
the back with one hand and the inner side
of the front, as shown. Do not grip the base
because it is not designed for lifting.
C10
Moving the Dock
C7
VibraRise Mop Cloth
* Clean every 2 weeks and replace every 6-12 months.
Use a soft dry cloth to wipe the charging
contacts on the robot and the dock.
C9
Charging Contact Areas
* Clean as required.
C6-1—
Use a soft, dry cloth to wipe and clean all
sensors, including:
C8
Robot Sensors
* Clean as required.
Reactive 3D Obstacle Avoidance
Sensor
Mop Wash Sensor
Wall Sensor
Carpet Sensor
Cliff Sensors
C8-1—
C8-2—
C8-3—
C8-4—
C8-5—
* Clean as required.
Clean the dirty water tank as needed. Open
the dirty water tank lid and pour out the
dirty water. Fill the tank with clean water,
close the lid, lock it, and shake. Pour out the
dirty water. Close the lid and then re-install.
C11
Dirty Water Tank
* Clean as required.
Unlock the water filter and remove it from
dock. Unlock the filter latch, rinse the filter
clean. Use a soft, dry cloth to wipe the
cleaning tank, and then reinstall the filter.
Press down the filter until you hear it lock
with a click.
C13
Water Filter
Lift the high-speed maintenance brush latch
and remove the brush, as shown below.
Remove any entangled objects in the high-
speed maintenance brush and rinse it clean.
Reinstall the brush and latch it in place.
* Clean as required and replace every 6-12 months.
C12
High-Speed Maintenance
Brush
Open the top cover of the robot and
press the dustbin latch to take out
the dustbin.
Press the cover latch to open the
dustbin cover and remove the
washable filter, then empty the
dustbin.
Fill the dustbin with clean water and
close the cover. Gently shake the
dustbin, and then pour out the dirty
water.
Leave the dustbin and the washable
filter to dry.
C5
Dustbin
C5-2—
C5-1—
* Clean as required.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
C5-3—
C5-4—