Eiki PJNET-300 - Manual (Page 43)

43
OWNER'S MANUAL
ENGLISH
System
This function is to select the system of signal input to the projector. The available
system mode are listed on the pull-down menu button according to the input signal.
Select a system and then click Set button.
Available selection when the Computer[Analog] input
Item Description
XGA1 ................. It automatically switches to the proper computer
system of the input signal.
* The computer system modes (VGA, SVGA, XGA.
SXGA, UXGA, WXGA...) which meet the input
signal are listed.
✐ If the mode (Mode1 to Mode 10, ExMode11 to ExMode50)
which is stored in the item "PC Adjustment" (☞ p.46) is avail-
able, they are also listed together with the above mode.
Available selection when the VIDEO/S-VIDEO input
Item Description
AUTO ................. It automatically switches to the proper color sys-
tem of the input signal.
* The selectable color systems are PAL, SECAM,
NTSC, NTSC4.43, PAL-M and PAL-N.
✐ If the mode (ExMode11 to ExMode50) which is stored in
the item "PC Adjustment" (☞ p.46) is available, they are also
listed together with the above mode.
Available selection when the Y, Pb/Cb, Pr/Cr input
Item Description
AUTO ................. It automatically switches to the proper scanning
system of the input signal.
* The selectable scanning systems are 480i, 575i,
480p, 575p, 720p, 1035i and 1080i.
✐ If the mode (ExMode11 to ExMode50) which is stored in
the item "PC Adjustment" (☞ p.46) is available, they are also
listed together with the above mode.
Controls