Specifications, Dimensions, Clearances to combustibles – Enviro EG28 DV User Manual

Page 5: Preparation for installation

WARNING:
Operation of this heater when not connected to a properly installed and maintained venting system can result in

carbon monoxide (CO) poisoning and possible death.

Specifications

IMENSIONS

��

�

��

LEARANCES

OMBUSTIBLES

A. Sidewall to unit

10 inches (25.4 cm)

B. Backwall to unit

4 inches (10.2 cm)

C. Corner to unit

2 inches (5.1 cm)

D. Combustibles to unit top 22 inches (55.9 cm)

E. Floor to unit

0 inches

F. Alcove maximum depth:

48 inches (121.9 cm)

• Locate a position where the flue system of the stove can

be properly installed without damaging the integrity of the

building; e.g. cutting a wall or ceiling joist.

• Check stove and flue system clearance requirements.

• Locate the stove where it can be accessed by a gas supply line.

• Locate the stove in a large and open room that is centrally located in the house. This will optimize heat circulation

and comfort.

• As the stove is equipped with a convection fan, ensure that an electrical outlet is within 6 feet. (1.8 m) of the

stove.

• The flow of combustion and ventilation air must not be obstructed.

CLEARANCES MUST BE SUFFICIENT TO ALLOW ACCESS FOR MAINTENANCE AND SERVICE.

REPARATION

NSTALLATION

• Remove the packaging from the appliance, and check to make sure there is no damage. If damage is found,

please report it to both the carrier and your dealer as soon as possible.

• Before beginning, carefully check the glass door and the log set

Figure 1: EG28 Exterior Dimensions.

��

Figure 2: Clearances to combustibles.

This manual is related to the following products: