Enviro EG28 DV - Manual (Page 4)

DIRECT VENT: This type is identified by the suffix DV. This appliance draws all of its air for
combustion from outside the dwelling, through a specially designed vent pipe system.
This appliance has been tested and approved for installations from 0 feet to 4500 feet (1372 m) above sea level.
In the USA: The appliance may be installed at higher altitudes. Please refer to your American Gas Association
guidelines which state: the sea level rated input of Gas Designed Appliances installed at elevations above 2000
feet (610 m) is to be reduced 4% for each 1000 feet (305 m) above sea level. Refer also to local authorities or
codes which have jurisdiction in your area regarding the de-rate guidelines.
In Canada: When the appliance is installed at elevations above 4500 feet (1372 m), the certified high altitude
rating shall be reduced at the rate of 4% for each additional 1000 feet (305 m).
• This appliance has been tested by INTERTEK (Warnock Hersey) and found to comply with the established
VENTED GAS FIREPLACE HEATER standards in CANADA and the USA as follows:
VENTED GAS FIREPLACE HEATER (EG28 DV NG/LPG)
TESTED TO: ANSI Z21.88a-2003/CSA 2.33a-2003 VENTED GAS FIREPLACE HEATERS
CAN/CGA 2.17-M91 GAS FIRED APPLIANCES FOR HIGH ALTITUDES
CSA P.4.1-02 TESTING METHOD FOR MEASURING ANNUAL FIREPLACE EFFICIENCY
This ENVIRO EG28 DV Fireplace:
• Has been certified for use with either natural or propane gases. (See rating label.)
• Is not for use with solid fuels.
• Is approved for bedroom or bed sitting room. (IN CANADA: must be installed with a listed wall thermostat. IN
USA: see current ANSI Z223.1 for installation instructions.)
• Must be installed in accordance with local codes. If none exist, use current installation code CAN/CGA B149 in
Canada or ANSI Z223.1/NFPA 54 in the USA.
• Must be properly connected to an approved venting system and not connected to a chimney flue serving a
separate solid-fuel burning appliance.
• Manufactured (mobile) home installation must be in accordance with the Manufactured
Home Construction and Safety Standard, UL 307B, Title 24 CFR, Part 3280 and/or
The Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A. The
unit must be bolted to the floor of the mobile home and must be electrically grounded
to the steel chassis.
• Are approved for installation on combustible materials (i.e. Wood, carpet or
linoleum).
• Is not approved for closet or recessed installations.
IMPORTANT NOTICE (Regarding first fire up): When the unit is turned on for the
first time, it should be turned onto high without the fan on for the first 4 hours. This
will cure the paint, logs, gasket material and other products used in the manufacturing
process. It is advisable to open a window or door, as the unit will start to smoke and
can irritate some people. After the unit has gone through the first burn turn the unit
off including the pilot, let the unit get cold then remove the glass door and clean it
with a good gas fireplace glass cleaner, available at your local ENVIRO dealer.
4
Codes And Approvals