Operation, Starting up the projector, Starting up the – BenQ TH670s User Manual
Page 24
Operation
24
Operation
Starting up the projector
1.
Plug the power cord into the projector and
into a power outlet. Check that the POWER
indicator light on the projector lights
orange after power has been applied.
•
Please use the original accessories (e.g. power
cable) only with the device to avoid possible
dangers such as electric shock and fire.
•
If Direct Power On function (in the Advanced
menu > System Setup: Basic)* is activated, the projector will turn on
automatically after the power cord has been connected and power has been
applied. See
for details.
•
*There are two menu types for your selection. One is Basic, and the other is
Advanced. From the Basic menu, you can select Menu Type when the projector
is without input signal. From the Advanced menu, you can select Menu Type in
the System Setup: Basic > Menu Settings menu. See
for details.
2.
Make sure the lens cover is open. If it is
closed, it could become deformed due to the
heat produced by the projection lamp.
3.
Press
POWER on the projector or
ON on the remote control to start the
projector. The POWER indicator light
flashes and stays green when the projector
is on.
The start up procedure takes about 10-20
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Use the focus ring to adjust the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for
approximately 90 seconds before energizing the lamp.
4.
If the projector is activated for the first time, follow the on-screen instructions
to complete the setup.
5.
If you are prompted for a password, press the arrow keys to enter a six digit
password. See
"Utilizing the password function" on page 31
for details.
6.
Switch all of the connected equipment on.
I
I