ProSoft Technology BM-1000-PM1K - Manual (Page 16)

Installation
Page 16 of 36 ProSoft Technology, Inc.
June 10, 2015
4.2 RS485 I/O Expansion System Assembly
Warning: Power must be disconnected or turned off prior to attaching or removing any I/O
Modules from the system – failure to comply may cause damage hardware.
1. Securely attach the DataRail onto a 35 mm x 7.5 mm DIN rail by gently
pressing on all four (4) corner clips.
2. Secure DataRail to DIN rail by attaching an End Terminal Bracket.
a. First, hook the metal end of the Bracket to DIN rail and then snap the
other end onto the DIN rail. (Make sure to position the Bracket on the far
left of the DataRail where metal blades meet the plastic).