PLANET ISW-1022M - Manual (Page 5)

3. Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of ISW-1022M is used for
two DC redundant power input. Please follow the steps below to insert the power
wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for POWER
2, or 5 and 6 for POWER 1.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
1 2 3 4 5 6
Power 2 Power 1
- + - +
Note
The wire gauge for the terminal block should be in the range
between 12 ~ 24 AWG.