PLANET CS-500 - Manual (Page 10)

8 9
disconnection. Enter 0 if you do not want the PPPoE connection to discon-
nect at all.
Ping: Select this to allow the WAN network to ping the IP Address of the Content Security
Gateway. This will allow people from the Internet to be able to ping the Content Security
Gateway. If set to enable, the device will respond to echo request packets from the WAN
network.
WebUI: Select this to allow the device WEBUI to be accessed from the WAN network. This
will allow the WebUI to be configured from a user on the Internet. Keep in mind that the
device always requires a username and password to enter the WebUI.
5.3 Configure DMZ interface
Depends on your network requirement, you can disable the DMZ port, or make DMZ port
transparent to WAN or enable NAT function on it.
To configure the DMZ port, select the Interface tab on the left menu, then click on DMZ,
the following page is shown.
5.4 Configure Policy
STEP 1:
Click on the Policy tab from the main function menu, and then click on Outgoing (LAN to
WAN) from the sub-function list.
STEP 2:
Click on New Entry button.
STEP 3:
When the New Entry option appears, enter the following configuration:
Source Address select Inside_Any
Destination Address select Outside_Any
Service - select ANY
Action - select Permit
Click on OK to apply the changes.