PLANET CS-2000 - Manual (Page 5)

3. Setup the UTM Content Security Gateway
The followings are instructions for setting up PLANET CS-2000. Refer to the
illustration and follow the simple steps below to quickly install your UTM Content
Security Gateway.
Safety Instruction
The following is the safety instructions for UTM Content Security Gateway before
installing.
>> The maximum operating temperature of the UTM is 50ºC. Care must be taken
to allow sufficient air circulation or space between units when the UTM is
installed inside a closed rack assembly and racks should safely support the
combined weight of all UTM.
>> The connections and equipment that supply power to the UTM should be
capable of operating safely with the maximum power requirements of the
UTM. In the event of a power overload, the supply circuits and supply wiring
should not become hazardous.
>> The AC power cord must plug into the right supply voltage. Make sure that
the supplied AC voltage is correct and stable. If the input AC voltage is over
10% lower than the standard may cause the UTM to malfunction.
>> Generally, when installed after the final configuration, the product must
comply with the applicable safety standards and regulatory requirements of
the country in which it is installed. If necessary, consult for technical support.