PLANET CS-2000 - Manual (Page 11)

11
STEP 8:
When the New Entry option appears, enter the following configuration: (Figure-6)
Source Address – select “Inside_Any”
Destination Address – select “Outside_Any”
Service - select “ANY”
Action - select “Permit all”
Click on OK to apply the changes.
Figure-6 Add New Policy Setting
STEP 9:
The configuration is successful when the screen below is displayed. (Figure-7)
Figure-7 Complete Setting
Please make sure that all the computers that are connected to the LAN port have
their Default Gateway IP Address set to the Content Security Gateway’s LAN IP
Address (i.e. 192.168.1.1). At this point, all the computers on the LAN network
should gain access to the Internet immediately. If a Content Security Gateway filter
function is required, please refer to the Policy section in the user’s manual.
l
l
l
l