PLANET ADW-4100 - Manual (Page 42)

ADW-4100 User Manual
36
Using DHCP
To use DHCP, select the radio button Obtain an IP Address automatically. This is
the default Windows settings.
Restart your PC to ensure it obtains an IP Address from ADW-4100.
Using a fixed IP Address ("Use the following IP Address")
•
If your PC is already configured, do NOT change the settings on the screen
shown in Figure above, unless advised to do so by your network administrator.
•
You can enter ADW-4100's IP address in the Default gateway field and click
OK. Your LAN administrator can advise you of the IP Address they assigned to
ADW-4100.
•
If the DNS Server fields are empty, select Use the following DNS server ad-
dresses, and enter the DNS address or addresses provided by your ISP, then
click OK.
Internet Access
To configure your PCs to use ADW-4100 for Internet access:
•
Use the following procedure to configure your Browser to access the Internet
via the LAN, rather than by a Dial-up connection.
Windows 9x/2000
1. Select Start Menu - Settings - Control Panel - Internet Options.
2. Select the Connection tab, and click the Setup button.
3. Select "I want to set up my Internet connection manually, or I want to connect
through a local area network (LAN)" and click Next.
4. Select "I connect through a local area network (LAN)" and click Next.
5. Ensure all of the boxes on the following Local area network Internet Configura-
tion screen are unchecked.
6. Check the "No" option when prompted "Do you want to set up an Internet mail
account now?"
7. Click Finish to close the Internet Connection Wizard.
Setup is now completed.
Windows XP
1. Select Start Menu - Control Panel - Network and Internet Connections.
2. Select Set up or change your Internet Connection.
3. Select the Connection tab, and click the Setup button.
4. Cancel the pop-up "Location Information" screen.
5. Click Next on the "New Connection Wizard" screen.
6. Select "Connect to the Internet" and click Next.
7. Select "Set up my connection manually" and click Next.
8. Check "Connect using a broadband connection that is always on" and click
Next.
9. Click Finish to close the New Connection Wizard.
Setup is now completed.