PLANET VIP-193 - Manual (Page 76)

8. Repeat steps 5-7 until you have entered all four port ranges for the Wi-Fi
Phone.
Application Start and End Protocol IP Address
Enable Internet phone 1 5060 to 5061 UDP (IP address of Wi-Fi Phone)
X Internet phone 2 53 to 53 UDP (IP address of Wi-Fi Phone)
X Internet phone 3 69 to 69 UDP (IP address of Wi-Fi Phone)
X Internet phone 4 10000 to 20000 UDP (IP address of Wi-Fi Phone)
9. Check the Enable option for the port services you want to use.
10. When you have completed the configuration, click the Save Settings button.
4. The power LED does not light up.
Go through this checklist until your problem is solved:
• Remove the Wi-Fi Phone’s battery from its compartment. Wait five seconds while the Wi-Fi Phone resets
itself. Insert the battery and power on the Wi-Fi Phone.
• You may be using the wrong power adapter. Make sure the power adapter you are using is the one
included with the Wi-Fi Phone.
71
Appendix A: Common Problem and Solutions