Avago Technologies ACPL-064L-000E - Manual (Page 2)

1
1
2
2
3
3
4
4
5
5
6
6
D D
C C
B B
A A
Title
Number Revision Size
B
Date: 17.11.2009 Sheet of
File: D:\AgilProj\..\LowPowTestPCB.sch Drawn By:
Low Power Optocoupler
Evaluation PCB
6
7
VCC
8
GND
5
1
2
3
4
U1
ACPL-064L
5
VCC
6
GND
4
1
3
U2
ACPL-M61L
R1 510R 1%
C1
100nF
C2
100nF
R4 510R 1%
R5
510R 1%
GND2
GND2
GND2
1
2
3
4
5
P2
Side 2
1
2
3
4
5
P1
Side 1
GND2
I
Please note:
LED resistors are dimensioned for 3.3 V operation.
R2 360R 1%
R3 360R 1%
R6
360R 1%
GND1
GND1
GND1
GND1
CLK in
SDI in
GND1
SDO out
Vcc1
Vcc2
CLK out
SDI out
GND2
SDO in
For product information and a complete list of distributors, please go to our web site: www.avagotech.com
Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies in the United States and other countries.
Data subject to change. Copyright © 2005-2011 Avago Technologies. All rights reserved.
AV02-3160EN - September 5, 2011
Board Connection and Operation
ACPL-064L (SO8 dual-channel)
1. Connect input signal (3.3 V, pulse) to P1-1 for 1st
channel, and P1-2 for 2nd channel.
2. Connect input ground to P1-3.
3. Connect 3.3 V (or 5 V) power supply to P2-1 for V
CC
, and
P2-4 for GND.
4. Probe output signal at P2-2 for 1st channel, and P2-3
for 2nd channel.
ACPL-M61L (SO5 single-channel)
1. Connect input signal (3.3 V, pulse) to P2-5.
2. Connect input ground to P2-4.
3. Connect 3.3 V (or 5 V) power supply to P1-5 for V
CC
, and
P1-3 for GND.
4. Probe output signal at P1-4.
Please note:
Input LEDs are dimensioned for 3.3 V operation.
Figure 1. Schematic Diagram for ACPL-M61L/064L Evaluation Board
Figure 2. Top Layer View
21.5
5-pin
Header P1
1 CLK in
4 SD0 out
5 Vcc1
2 SD1 in
3 GND1
6 Vcc2
9 GND2
10 SD0 in
7 CLK out
8 SD1 out
Dimensions are in mm
13.208
ACPL-M61L
ACPL-064L 5-pin
Header P2