Avago Technologies LSI SAS 3041X-R - Manual (Page 23)

Detailed Installation Instructions 2-3
Version 2.1 Copyright © 2005, 2006 by LSI Logic Corporation. All rights reserved.
Step 7. Replace the cover and the power cord(s), then power-up the
system.
Replace the system’s cover, reconnect the power cord(s) and
any network cables. Turn power on to the system.
The PCI-X to 3.0 Gbit/s SAS host adapter hardware installation is
complete.
Figure 2.1 Installing a PCI-X to 3.0 Gbit/s SAS x4 Host Adapter in
a PCI-X Slot
32-bit Slots
64-bit Slots
(3.3 V)
(3.3 V)
Edge of
Host Board
Bracket
Press Here
Press Here
HDD
Connector
Serial Signal
Cable
HBA Single
Lane Connector
Screw