Avago Technologies eXtremeRAID 3000 - Manual (Page 18)

Installing the eXtremeRAID 3000 into the System Board
6 eXtremeRAID 3000 Quick Installation Guide
8. Connect a Fibre cable, with the High Speed Serial Data Connector
(HSSDC), to either one or both of the external Fibre connectors on the
eXtremeRAID 3000 controller. Connect the other end of the Fibre
cable, with a 9-Pin DSUB connector, to other devices or to a Fibre
Channel Cabinet external drive cabinet, as required (see Figure 6).
Figure 6. External Fibre Drive Configuration
Figure 7. eXtremeRAID 3000 in a Typical Installation
Using Fibre and SCSI Connectors
The hardware portion of the installation is complete.
Please see the following section titled “What to Do Next.”