Avago Technologies AcceleRAID 352 - Manual (Page 19)

Hardware Installation
Manual No. DB11-00027-00 7
☛
Note
The AcceleRAID 352 terminator is ON by default.
It is automatically terminated and will be disabled
automatically if necessary.
An example of a typical, completed installation of the AcceleRAID 352 is
shown in Figure 7.
Figure 7. AcceleRAID 352 in a Typical Installation
and SCSI Connectors
The hardware portion of the installation is complete.
Please see the following section titled “What to Do Next”.
What to Do Next
1. Use RAID EzAssist to create an automatic or a custom RAID
configuration.
Refer to the RAID EzAssist Configuration Utility Quick Configuration
Guide or RAID EzAssist Configuration Utility User Reference Guide.
2. Install the AcceleRAID 352 controller drivers appropriate for your
server’s network operating system.
Refer to the PCI Disk Array Controller Drivers Installation Guide and
User Manual.
System Board
T
T