Avago Technologies MegaRAID SCSI 320-0X (530) - Manual

®
This document describes how to install the MegaRAID SCSI
320-0X ZCR (zero-channel RAID) controller. The MegaRAID
SCSI 320-0X ZCR Controller can be installed in a special
PCI-X expansion slot in a computer with a mainboard that
has the LSI Logic 53C1020 or 53C1030 SCSI chip.
The zero-channel adapter converts a mainboard’s onboard
SCSI controller into a powerful PCI-X SCSI RAID solution
and is targeted for one-unit and two-unit server
environments.
M e g a R A I D S C S I 3 2 0 - 0 X Z C R C O N T R O L L E R
I N S T A L L A T I O N
Perform the following steps to install the MegaRAID SCSI
320-0X ZCR Controller:
Step 1 Unpack the MegaRAID SCSI 320-0X ZCR
Controller
Unpack the MegaRAID SCSI 320-0X ZCR
Controller in a static-free environment. Remove
the MegaRAID SCSI 320-0X ZCR Controller from
the antistatic bag and inspect it for damage.
If the MegaRAID SCSI 320-0X ZCR Controller
appears to be damaged, or if the MegaRAID
Universal Software Suite CD is missing, contact
LSI Logic or your MegaRAID OEM support
representative.
The CD contains utility programs, device drivers
for various operating systems, and the following
documentation:
•
MegaRAID 320-0X Zero-Channel PCI-X RAID
Storage Adapter User’s Guide
•
MegaRAID Configuration Software User’s
Guide
•
MegaRAID Device Driver Installation User’s
Guide
•
Software license agreement and warranty
registration card
Step 2 Prepare the Computer
Turn off the computer and unplug the power
cord(s) from the back of the power supply.
Remove the cover from the chassis.
Step 3 Review the MegaRAID Controller Jumpers and
Connectors
Figure 1 shows the location of the jumpers and
connectors on the MegaRAID SCSI 320-0X ZCR
Controller. The jumpers are set at the factory and
you usually do not need to change them.
Figure 1 MegaRAID SCSI 320-0X ZCR Controller
Card Layout
The MegaRAID SCSI 320-0X ZCR Controller is
for use only in mainboards that have ZCR slots.
Make sure that your mainboard has a ZCR slot
available for this controller.
Make a backup of your data before you change
your system configuration to ensure no loss of
data.
!
CAUTION
!
CAUTION
Make sure the computer is disconnected from the
power and from any networks before installing
the controller.
!
CAUTION
J2
J1
J3
J4
J5
J6
J7
J8
J9
LSI Logic MegaRAID
®
SCSI 320-0X ZCR Controller
Quick Installation Guide