Lsiibbu01 hardware specifications – Avago Technologies MegaRAID SATA 300-8X User Manual
Page 2
Order No. S14079
P/N: 80-00055-01
DB11-000061-00, Version 1.0,
October 2004
Find a list of LSI Logic Corporation’s U.S. distributors, international distributors,
sales offices, and design resource centers on the LSI Logic web site at:
®
LSI Logic, the LSI Logic logo design, and MegaRAID are trademarks or registered
trademarks of LSI Logic Corporation. All other brand and product names may be
trademarks of their respective companies.
Copyright © 2004 by LSI Logic Corporation. All rights reserved.
LSI Logic Corporation reserves the right to make changes to any products and ser-
vices herein at any time without notice. LSI Logic does not assume any responsi-
bility or liability arising out of the application or use of any product or service
described herein, except as expressly agreed to in writing by LSI Logic; nor does
the purchase, lease, or use of a product or service from LSI Logic convey a license
under any patent rights, copyrights, trademark rights, or any other of the intellec-
tual property rights of LSI Logic or of third parties.
Figure 2 Connecting the LSIiBBU01
Step 5
Carefully press the LSIiBBU01 onto the storage
adapter, so the J3 and J14 connectors are firmly
joined.
Step 6
Using the three Philips-head screws that are
provided, secure the LSIiBBU01 to the storage
adapter, as shown in
Figure 2
.
Caution:
Center the screwdriver carefully to avoid stripping
the screw heads. Do not over-tighten the screws.
The maximum recommended torque is 2.25 inch
pounds.
Step 7
Install the MegaRAID SATA 300 storage adapter
in a PCI-X slot in the computer, as shown in
Figure 3
.
Press down gently, but firmly, to ensure that the
storage adapter is properly seated in the slot. The
bottom edge of the storage adapter must be flush
with the slot.
Caution:
Never apply pressure to the LSIiBBU01 when
inserting the adapter. Instead, press down only
on the top edge of the storage adapter board, as
shown in
Figure 3
.
Step 8
Attach the storage adapter to the computer
chassis with the bracket screw.
Figure 3 Installing the Storage Adapter
Step 9
Attach the cables, as needed, to the connectors
on the MegaRAID SATA 300 storage adapter.
Step 10
Replace the computer cover and reattach the
power cord(s).
L S I i B B U 0 1 H a r d w a r e S p e c i f i c a t i o n s
•
Supports DDR1 memory technology.
•
Can be used with models 300-8X and 300-4X of the
MegaRAID SATA 300 storage adapter.
•
Battery capacity is 4.22 Wh.
•
Reference retention time is 72 hours for 128 MB standard
cache on the MegaRAID SATA 300 storage adapter,
using 256Mb x 16 DDR1 memory chips.
•
LSI Logic recommends that you replace the LSIiBBU01
after one year of service.
J3
Connector
64-bit Slots
(3.3 V)
Bracket Screw
Press Here
Press Here
MR_LSIiBBU01_QuickIG.fm Page 2 Thursday, October 14, 2004 4:22 PM