Avago Technologies Syncro CS 9271-8i - Manual (Page 4)

LSI Corporation
- 4 -
Syncro CS 9271-8i Controller Quick Installation Guide
October 2013 Installation Instructions
2. Install the Syncro CS 9271-8i controller assemblies.
Turn off the host computer, and unplug the power cords from the rear of the power supply. Remove the cover
from the host computer. Install the controller and assemblies as shown in the following figure.
Figure 2 Installing the Syncro CS 9271-8i Controller Assemblies
NOTE Because server and workstation chassis vary from vendor to vendor,
no standard mounting option exists for the CVPM02 module that is
compatible with the various system configurations. Authorized
resellers and chassis manufacturers can customize the location of the
power module to provide the most flexibility in various environments.
If you are mounting this controller in a Cluster-in-a-Box, refer to the
instructions from the CiB vendor on how to mount a CVPM02 module.
NOTE Refer to the Syncro CS 9271-8i Solution User Guide on the Syncro CS
Resource CD for more detailed hardware setup instructions. If you want
to replace a bracket, refer to the Replacing Brackets on MegaRAID®
SAS+SATA RAID Controllers Quick Installation Guide for instructions.
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
Press
Here
3_02032-02
Power Module
Mouting Clip
J5A1
J5B1
J2B1
CVPM02
Module
CVFM02
Module
Power Module
Cable
Bracket
Mounting
Screw