Avago Technologies SAS 9207-8i Host Bus Adapter - Manual (Page 8)

Avago Technologies
- 8 -
LSI SAS 9207-8i PCI Express to 6Gb/s SAS HBA User Guide
October 2014 Technical Support
Figure 2 Installing an LSI SAS 9207-8i HBA in a PCI Express Slot
NOTE The shape, size, and locations of components on your HBA and its
bracket might vary from this illustration. The LSI SAS 9207-8i HBA
requires a x8 PCIe slot.
6. Secure the HBA bracket to the system’s chassis. Install the bracket screw, if applicable, or engage the system
retention mechanism to secure the HBA to the system’s chassis.
7. Connect SAS cables between the HBA and the SAS backplane or any other SATA or SAS devices. Connect
serial cables between the HBA and the SAS backplane or any other SATA or SAS devices. The preceding figure
shows the locations of the HBA connectors. The LSI SAS 9207-8i HBA has two internal x4 mini-SAS, SFF-8087
connectors that the LSI SAS 9207-8i HBA kit includes. You may use other appropriate cables to a specific system.
8. Replace the cover and any power cords, and power up the system. Replace the chassis’s cover, reconnect any
power cords, and reconnect any network cables. Turn on the power.
The hardware installation of your LSI SAS 9207-8i HBA is complete.
8 Technical Support
For assistance installing, configuring, or running the LSI SAS 9207-8i HBA, contact Technical Support:
E-mail: [email protected]
Web Site: www.lsi.com/support/
32-Bit Slots
64-Bit Slot
Edge of
Host Board
Bracket
Screw
Press
PCIe x8 Slot
Here
Press
Here
Mini-SAS x4 (SFF-8087)
Internal Connector with Shell
Mini-SAS x4 (SFF-8087)
to SAS x1 Internal
Fan-Out Cable