Amprobe AT-5000 Underground-Wire-Tracer - Manual (Page 39)

37
7. Make sure that a distance of at least 50-FT (15m) is always maintained between the receiver and transmitter in order to
prevent the coupling of the transmitter’s signal through the air.
Locating Passive Lines (Radio and Power Modes)
The R-5000 Receiver can locate passive cables that carry radio signals in the frequency range between 15 kHz and 23 kHz as well
as power signals between the range of 50 Hz and 60 Hz without the help of the T-5000 Transmitter.
Turn the R-5000 Receiver on 1.
Select radio mode or power mode. 2.
Set the sensitivity to maximum 3.
Sweep the area using a grid pattern as shown below 4.
Adjust the sensitivity to pinpoint the conductor 5.