Amprobe AT-7000 - Manual (Page 33)

29
1. Make sure that the Transmitter is turned off.
2. Use the star screw driver to unscrew the holding screws.
3. Remove the battery cover.
4. Install Batteries using the battery clip.
5. Replace the battery cover and secure it with the provided screw.
Changing receiver battery:
The battery compartment on the back of the AT-7000-R is designed to make changing
batteries easy. Four (4) AA 1.5V alkaline or 1.2V rechargeable batteries may be used.
Figure 5.2: Changing receiver battery
1. Make sure that the Receiver is turned off.
2. Use screw driver to unscrew the captive screw.
3. Remove the battery cover.
4. Install batteries using the battery clip.
5. Replace the battery cover and secure it with the
provided screw.
Transmitter battery charging:
The BR-7000 Signal Booster Rechargeable Battery Pack will
automatically begin recharging whenever the Transmitter
is connected to an energized circuit with voltage between
90-270 Volts AC. When connected to an energized circuit the
Transmitter does not need a battery as the Transmitter uses
power from the line.
5. maintenance
Figure 5.3
Transmitter battery charging