Amprobe MEGATEST-5000 Megohmmeter - Manual (Page 16)

4.4.2 Previously memorised configurations
When performing the same measurements on the same kind of equipment, a measuring
configuration can be memorised for each usual situation, for example:
• P01 Measuring on A-type product.
• P02 Measuring on B-type product.
• P03 Measuring on C-type product.
The measuring configurations can also be divided up into groups used by different
operators. E.g.:
• P01 - P05 Measurements usually performed by operator 1
• P06 - P10 Measurements usually performed by operator 2
• P11 - P15 Measurements usually performed by operator 3
In each case, all that is required is for the operator to use the arrow keys to go to the
desired configuration and then to press Start to begin measuring.
4.4.3 Extemporaneous instrument configuration
Select a configuration and modify it as described under Section 4.5, Instrument
Configuration and Measurement Performance, then use the Start key to run it. If the
modified configuration is not saved, it will stay active only until a new selection is made or
the instrument is turned off.
-14-