Epson 220 - Manual (Page 2)

EPSON LQ-2080
2 - EPSON LQ-2080 2/99
Optional Interface Cards
You can install an optional interface card to supplement your
printer’s built-in parallel interface and provide added network
compatibility. The EPSON interface cards in the table below
are compatible with your printer. (Not all interfaces are
available in all countries.)
The asterisk (✽) is a substitute for the last digit, which varies by country.
Printer Specifications
Mechanical
Model number Name
C82305✽ / C82306✽ Serial interface card
C82307✽ / C82308✽ 32KB intelligent serial interface card
C82310✽ / C82311✽ 32KB intelligent parallel interface card
C82312✽ LocalTalk interface card
C82313✽ 32KB IEEE-488 interface card
C82314✽ Coax interface card
C82315✽ Twinax interface card
C82345✽ IEEE-1284 parallel interface card
C82357✽ / C82362✽ /
C82364✽ Ethernet interface card
Printing method 24-pin impact dot matrix
Printing speed High-speed draft
400 cps at 10 cpi maximum
Draft
300 cps at 10 cpi
Letter-quality
100 cps at 10 cpi
Printing direction Bidirectional logic seeking for text and
graphics printing. Unidirectional text
or graphics printing can be selected
using software commands.
Line spacing 1/6-inch or programmable in
1/360-inch increments
Printable columns 136 columns (at 10 cpi)
Resolution Maximum
360
×
180 dpi (letter quality)
360
×
360 dpi (raster graphics)
Interfaces One standard bidirectional, 8-bit,
parallel interface with IEEE 1284
nibble mode support and one optional
interface slot
Paper feed methods Friction (front or top paper entry)
Push tractor (front or rear paper entry)
Pull tractor (optional—front, bottom,
or rear paper entry)
Push and pull tractor (optional)
Cut-sheet feeder (optional)
Roll paper holder (optional)
Paper feed speed Continuous
5 inches/second
Intermittent
45 ms/line at 1/6-inch line spacing
Paper capacity High-capacity cut-sheet feeder
up to 150 sheets of 22 lb
(82 g/m
2 ) paper
up to 25 plain or bond envelopes
up to 30 airmail envelopes
up to 30 postcards
a stack of multipart forms up to
0.59 inch (15 mm) thick
Note:
The thickness of the paper stack can be up to 0.59 inch (15 mm).
Second-bin cut-sheet feeder
up to 150 sheets of 22 lb
(82 g/m
2 ) paper
Note:
The thickness of the paper stack can be up to 0.20 inch (5 mm).
Buffer 64KB or 0KB (selectable in the
default-setting mode or the EPSON
Remote! utility)