Whelen 7096301 - Manual

Page 1
12.0” ±1.0”
MODELS 7096303
& 7096304 SHOWN
FOR REFERENCE.
.156 DIA. MTG HOLE
(2 PLACES)
.225
1.625*
*1.65 for models:
709630
709630
0
1
2
1.390
1.050
2.10
2.10 DIA.
1.98
4.939
1.000
1.275
CONNECTOR SHOWN
FOR MODELS 7096301
& 7096302 MODELS 7096305,
7096306 & 7096307
SHOWN
.075
1.98
4.017
.075
.19
.93
The conditions and tests required for TSO approval of this
article are minimum performance standards. It is the
responsibility of those installing this article either on or
within a specific type or class of aircraft to determine that
the aircraft installation conditions are within the TSO
standards. TSO articles must have separate approval for
installation in aircraft. The article may be installed only if
performed under 14 CFR part 43 or the applicable
airworthiness requirements.
®
ENGINEERING COMPANY INC.
Route 145, Winthrop Road,
Chester, Connecticut 06412
Phone: (860) 526-9504
Fax: (860) 526-2009
Internet: www.whelen.com
Sales/Service e-mail: [email protected]
Aviation
Installation Guide:
Model 70963( )-series
Models 7096301, 7096302, 7096303,
7096304, 7096305, 7096306, 7096307
P/N: 01-0770963-01, 01-0770963-02
01-0770963-03, 01-0770963-04
01-0770963-05, 01-0770963-06
01-0770963-07
LED Forward Position Light Assembly
©2004 Whelen Engineering Company Inc.
Form No.13911D (052214)
TSO-C30c
TYPES I & II
APPROVED
MADE IN THE U.S.A.
OPERATING INSTRUCTIONS:
Operational Voltage: . . . . . 22-30 VDC (28 VDC nom)
Nominal Input Current: . . . 0.3 Amps
EQUIPMENT LIMITATIONS: An approved forward position
lighting system consists of two lights, one located on each
wingtip. The lights must be installed under a protective lens.
Additional testing may be required.
CONTINUED AIRWORTHINESS: The 70963 series LED
wingtip position light assembly is designed with 6 LED’s. If
any one LED fails, the unit must be repaired or replaced.
Note: To reduce eyestrain, use an optical filter such as dark
glasses or a blue covering dome during LED inspection.
INSTALLATION PROCEDURES: The following information
is to assist in the installation of a Whelen LED Forward
Position Light System.
1. Choose the appropriate 70963( ) series replacement
light assembly.
2. The installation procedure described in the following
text will be confined to a single light installation, but is
identical for multiple light installations.
3. Remove the old light, locate and save the existing
+28VDC lead and (-) ground lead. Clean and prep
ends as required.
4. Connect the existing +28VDC and existing ground
leads. Both leads must be connected by an approved
FAA connection. Insure that wire leads are clear of any
obstacles and ty-wrap as required. CAUTION! Do not
touch the LED with either fingers or sharp objects. This
could soil and/or damage the LED and effect its optical
performance.
5. Position the base of the new light assembly onto the
mounting surface. Install using the existing hardware.
6. Check all avionics systems for interference from the
installation.
7. A flight check should be performed by a properly
certified pilot.
8. Update aircraft records, complete Form 337 and obtain
FAA field approval for installation, if necessary.