Whelen 90193 User Manual
Whelen Air equipment
1.08
1.03
2.46
3.450
DIMENSIONS
MODEL 90193 - ( )
1.79
SPECIFICATIONS:
Nominal Operational Voltage: ........................................ 28 VDC
Average Input Current: ..................................................... 1 AMP
Lamp for all Units: ....................................28VDC, 26 Watts Max.
EQUIPMENT LIMITATIONS:
An approved Anti-Collision / Position System consists of two
assemblies, one located on each wingtip.
INSTALLATION PROCEDURES: The following information is to
assist you in installing a Whelen Anti-Collision / Position light
system.
1)
Choose the appropriate Model 90193 - ( ) replacement light
assembly.
2)
The installation procedure described in the following text will
be confined to a single light installation, but is identical for
multiple light installation.
3)
Remove old anti-collision light, locate and record existing
+28 VDC and (-) ground terminal block position and output
connector from power supply.
4)
Use existing mounting holes and hardware.
5)
Connect leads from light assembly to terminal block in
recorded manner and lead from light to power supply.
6)
Breaker Requirements
Make sure existing system is equipped with an appropriate
sized breaker.
7)
Install light assembly and insure that all leads are clear of any
obstructions and ty-rap as required. Secure light assembly,
use lock washers and/or thread lock, on all threaded fasteners.
©1998 Whelen Engineering Company Inc.
Form No.13302A (021198)
ENGINEERING COMPANY INC.
ROUTE 145, WINTHROP ROAD
CHESTER, CONNECTICUT 06412-0684
TELEPHONE: (860) 526-9504
FAX: (860) 526-4078
8)
Check all avionics systems for interference from this
installation.
9)
A flight check should be performed by a properly certified
pilot.
10) When necessary, waterproof the light assembly to aircraft.
Apply single part silicone (RTV) or equivalent around any
open area where water could get in.
11) Update aircraft records and complete Form 337.
12) Obtain FAA field approval for installation.
Installation Guide for Model 90193 - ( )
Anti-Collision / Position Light Assembly
MADE IN THE U.S.A.
FAA / TSO C30b TYPE 1 & 2
and
FAA / TSO - C96a
APPROVED
Model 90193 - ( )
Anti-Collision / Position
Light Assembly