Whelen 90206 Series Light - Manual

Page 1
®
ENGINEERING COMPANY INC.
Route 145, Winthrop Road,
Chester, Connecticut 06412
Phone: (860) 526-9504
Fax: (860) 526-2009
Internet: www.whelen.com
Sales/Service e-mail: [email protected]
Aviation
©1998 Whelen Engineering Company Inc.
Form No.13304C (052102)
Wingtip Light & Power Supply Replacement Instructions
For Installation of: Whelen 90206 Series Light and
Whelen 90101 Series Power Supply
In Aircraft:Cessna 560 (Serial# 0001 to 0256) with Cessna Service
Bulletin SB560-33-08 Applied
Cessna 560 (Serial# 0257 & Above)
MOUNTING BRACKET LIPS
ON TOP OF EXISTING
BRACKETS
EXISTING
BRACKET
MOUNT. BRACKETS “A” & “B” TO SLOPE UPWARD FACING OUTBOARD OF AIRCRAFT WING
VIEW A-A
NOTE: ACCESS CUT-OUT SHOWN IN
ISOMETRIC DRAWINGS AS SEEN FROM
BELOW THE AIRCRAFT’S WING
EXISTING
BRACKET
EXISTING MOUNTING SCREWS (QTY. 4) TO SECURE
MOUNTING BRACKETS TO EXISTING BRACKETS
MOUNTING BRACKETS “A”
AND “B” ARE TO SLOPE
UPWARD FACING OUTBOARD
OF AIRCRAFT WING
OU
TB
OAR
D
MOUNTING BRACKET “B”
MOUNTING BRACKET “A”
OUTBOARD
INBOARD
EXISTING BRACKET
MOUNTING BRACKET “B”
PN / 11-170576-000
MOUNTING BRACKET “A”
PN / 11-170575-000
BRACKET LIP
BRACKET LIP
EXISTING
BRACKET
MOUNTING BRACKET
LIPS ON TOP OF EXISTING
BRACKETS
Strobe Light Power Supply
Installation:
PRELIMINARY: Disconnect battery and
external cart power sources from aircraft,
pull associated circuit breakers for strobe
light and position light wing systems.
1. From both wings of the aircraft, remove
the wingtip access panel by unscrewing
the mounting screws.
2. Remove existing strobe light power
supply from the wing-tip access cut-out
by removing the four mounting screws.
Disconnect cables from power supply.
3. Install the two supplied mounting
brackets (“A” and “B”) with lips on top of
existing brackets, located inside wing-
tip access cut-out, and secure with the
four mounting screws. IMPORTANT
NOTE: When brackets are installed,
insure that the upward slope is facing
outboard of the wing.
4. Connect the Whelen Strobe Light
Power Supply to the connectors of the
existing cables and install the power
supply onto “A” and “B” mounting
brackets with the connectors facing outboard. Secure the power
supply with the four #8-32 MS51957-46 mounting screws
(supplied) to the “A” and “B” mounting brackets.
5. Replace the wingtip access panel and secure with the mounting
screws.