Whelen Vendor Field Service - Manual (Page 2)

Page 2
Note - The following illustrations show a left Landing/Taxi light assembly to demonstrate the proper removal of a taxi light
reflector. This procedure is identical for the right side as well. Reverse this process for re-assembly.
Step 1 - Orient the assembly as shown. Rotate the lamp
assembly in a counter-clockwise direction. DO NOT TOUCH
THE BULB’S GLASS ENVELOPE WITH BARE HANDS!
Carefully remove the lamp assembly.
WARNING! Remove any grease or fingerprints from the
lamp glass envelope using a grease-free solvent such
as denatured alcohol or equivalent.
Step 3 - Obtain the correct reflector for the taxi light. When
properly oriented, the flat vertical reflector wall will be
positioned at the inboard end of the assembly and the lamp
opening will be aligned with the lamp mounting opening
in the assembly.
Step 2 - Locate, remove and retain the four (4) nuts, flat
washers and socket head bolts that secure the taxi reflector
to the assembly. Remove the taxi reflector from the
assembly.
Step 4 - Position the new reflector onto the assembly and
secure with the original hardware. Wipe the mirrored surface
of the installed reflector with a clean soft lint-free cloth to
remove any fingerprints or contaminants. Re-install the light
removed in step 1. Re-install completed assembly .
Taxi Light
Assembly
Manufactured Date Code
Taxi Light
Reflector
Taxi Light
Reflector
(correct orientation)
Inboard-end
of Assembly
Outboard-end
of Assembly
Flat Vertical
Reflector Wall
Taxi Lamp
Assembly
Landing Light
Assembly