End of wash cycle/removing the washing – Electrolux 61300 User Manual

Page 23

Text mode
Original mode

Operating Instructions

End of Wash Cycle/Removing the Washing

The washing program is completed when the ON/OFF button display

lamp goes out.
After a rinse hold
After a rinse hold the water must first be pumped out or the washing

spun:

Either turn the program selector clockwise to SPIN

(washing is spun in accordance with the program which has just run),

turn the program selector clockwise to PUMP OUT

(water is pumped out).
After the program has finished

4. Open the door.
5. Remove the washing.
6. Switch off the washing machine by pressing the ON/OFF button.
7. Close the water tap.
8. Pull the detergent drawer out a little so that it can dry. Leave the door

ajar for a while. This helps to prevent stagnant smells and helps to pre-

serve the door seal.
Important! If the washing machine is not to be used for a long period:

Unplug the appliance and turn off the water supply when the wash

program has finished.