SAF-HOLLAND XL-AR363-02 EDL/ARF Feature - Manual (Page 3)

XL-AR363-02 Rev. D 3
EXTERNAL DOCK LOCK (EDL) INSTALLATION
FIGURE 1
ITEM
NO. DESCRIPTION NS-xxx-16.0* NS-xxx-16.5* NS-xxx-17.0* NS-xxx-18.0* QTY.
1 EDL Rod Assembly 42˝ - 90546178 42˝ - 90546270 42˝ - 90546136 42˝ - 90546138 1
48˝ - 90546177 48˝ - 90546269 48˝ - 90546132 48˝ - 90546134
2 Hex Bolt 38 -16 x 1˝ 93002571 93400471 93400471 93400471 4
3 EDL Rod Support Plate 90034494 90034494 90034494 90034494 2
4 Hex Lock Nut 3/8˝ - 16 93400472 93400472 93400472 93400472 4
5 Hex Nut .50-13 93400136 93400136 93400136 93400136 2
6 Washer .53 93600072 93600072 93600072 93600072 2
7 EDL Actuator Chamber 90546122 90546122 90546122 90546122 1
8 Choke Valve 90054811 90054811 90054811 90054811 1
9 1 / 2 ˝ Clevis Assembly w/ 1 / 2 ˝ Pin 11M018-8 11M018-8 11M018-8 11M018-8 1
* “xxx” denotes models 400 or 450.
EDL Components
1
4
3
2
5
6
7
8
9
3
“A”
Ride Flipper Plate
Model No. Height Height
NS-400/450-16 16˝ (406mm) 6.5˝ (165mm)
NS-400/450-16.5 16.5˝ (419mm) 7.0˝ (178mm)
NS-400/450-17 17˝ (432mm) 7.5˝ (191mm)
NS-400/450-18 18˝ (457mm) 8.5˝ (216mm)
FIGURE 3
Flipper Plate
Ride
Height
“A”
Flipper Plate Height
5/8˝ (16mm)
Min.
Clearance
TABLE 1.
IMPORTANT:
Be certain the correct EDL assembly for the
suspension ride height is being installed. Various
suspension ride heights require different
assemblies with different flip plate heights. If
unsure of ride height, see FIGURE 3 and Table 1
or call SAF-HOLLAND Customer Service at
1-888-396-6501.
Suspension Ride Height Verification
1. Verify ride height by checking serial number tag located on the rear
crossmember (FIGURE 2).
If the serial number tag is not legible or unavailable, verify ride height
by measuring from the center of the axle to the bottom of the frame
or slider (FIGURE 3).
FIGURE 2
Serial Tag Location
Serial Number Tag Located
on Rear Crossmember
NOTE:
Example: NS-400/450-4818, last two digits
represent 18˝ (457mm) ride height.
2. Compare ride height to corresponding Flipper Plate Height from
Table 1 below (FIGURE 3).