beautypg.com

Switching on the hood - fig. 3, Switching on the light - fig. 3, Indicator light for grease or charcoal filter – Electrolux HD 8760 User Manual

Page 7: Led signal for grease filter, Led signal for charcoal filter, Re-setting the saturation signal

background image

7

Switching on the hood - Fig. 3

The control ball is a balancer switch.

Depressing the control ball repeatedly towards

the bottom, switches on the hood and you may

select the motor level desired, depressing once

again the hood switches off.

Switching on the light - Fig. 3

Depress the control ball towards the top :

once for reduced lighting,

once again for full lighting,

depress again to switch off the light.

Indicator light for grease or

charcoal filter

The air duct, in this hood, includes a device

that signals when the filter requires cleaning or

changing .

Led signal for grease filter

The LED signal flickers (flickering green light) when the grease filter

requires cleaning, occurs at about 40 operating hours.

Ensure that the indicator light is checked each time the hood is used.

Led signal for charcoal filter

The LED signal flickers (flickering orange light) when the charcoal filter

requires cleaning, occurs at about 160 operating hours.

Ensure that the indicator light is checked each time the hood is used.

Re-setting the saturation signal

After cleaning or replacing the filter, select the intensive speed (the

control ball lights up with a red flashing light), depress again and hold

depressed for about 3 seconds until an audible signal indicates the

reset has taken place.

depress towards

the top to switch

on the lights

depress towards the

bottom to switch on

the hood.

Fig. 3