beautypg.com

Control panel – Electrolux HD 8760 User Manual

Page 6

background image

6

Control Panel

• Best results are obtained by using a low speed for normal

conditions and a high speed when odours are more concentrated.

Turn the hood on a few minutes before you start cooking, you will

then get an under pressure in the kitchen. The hood should be left

on after cooking for about 15 minutes or until all the odours have

disappeared.

• The hood operation can be controlled via the control ball or with the

remote control (the remote control is a special accessory and is

ordered separately).

Every change (changing speed, switching on the lights, etc.) is

recognizable from the variation of light emitted by the control ball

and by an acoustic signal.

The control ball is located below on the right side of the cooker hood.

The control ball is also a light signal :

• No signal :

The hood is switched off.

• Static green light :

Hood is switched on at power level 1 (minimum).

• Static orange light :

Hood is switched on at power level 2 (medium).

• Static red light :

Hood is switched on at power level 3 (maximum).

• Flashing red light :

Hood is switched on at intensive power level (timed at 5 minutes)

• Flashing green light :

Indicates the grease filter saturation - clean the grease filter

• Flashing orange light :

Indicates the charcoal filter saturation - clean or replace the

charcoal filter.

Attention!

The control ball flashes orange to indicate the saturation of the

charcoal filter even if the hood is used in the extractor version and

no charcoal filter is fitted.

In this case, perform the signal reset operation as follows: select the

intensive speed (the control ball lights up with a red flashing light),

depress again and hold depressed for about 3 seconds until an

audible signal indicates the reset has taken place.