Extron Electronics RGB 160 - Manual (Page 6)

RGB 160xi and RGB 164xi • Controls and Installation
Controls and Installation
Front Panel Features
RGB 160
H. SHIFT
MIN/MAX
INPUTS
AUDIO ANALOG
BUFFERED LOCAL
MONITOR OUTPUT UNIVERSAL INTERFACE W/ADSP
ON
NO MONI
TO
R
NO MONI
TO
R
1 2 3 4 5 6 7
Figure 2-1 — RGB 160xi front panel
RGB 164xi
UNIVERSAL INTERFACE WITH ADSP™
MIN/MAX
H. SHIFT
AUDIO MONITOR COMPUTER
ON
NO MONI
TO
R
NO MONI
TO
R
INPUTS
1 2 4 5 3 6 7
Figure 2-2 — RGB 164xi front panel
1 2-color power/signal LED — Lights amber to indicate power
on only; lights green to indicate power on with video signal
present.
2 Audio input jack — 3.5 mm stereo input.
3 Analog input connector — 15-pin HD female analog video
input connector.
4 ID bit termination DIP switches — Provides proper ID bit
termination on the local monitor output for a laptop computer
that is not attached to a local monitor port.
5 Buffered local monitor output (RGB 160xi and RGB 164xi
only) — 15-pin HD female for output to a local monitor.
6 Horizontal shift control knob — Adjusts horizontal shifting of
the remote output display device.
DDSP disables horizontal shift.
7 Min/max LED — Lights red whenever the lower or upper limits
of the horizontal shift control is reached.
2-2 RGB 160xi and RGB 164xi • Controls and Installation 2-3
Rear Panel Features
Figure 2-3 — RGB 160xi rear panel
100-240V 0.5 A MAX
50-60Hz
UNITY
50%
100%
GAIN/
PEAK
SO
G
DDSP SERR SP
ARE
L R
AUDIO
R G B
H V S
OUTPUT 2 OUTPUT 1
R G B
H V S
8 10 9 13 11 12
Figure 2-4 — RGB 164xi rear panel
8 AC power input — Standard IEC AC power connector (100
- 240 VAC, 50/60 Hz).
9 3-position gain/peak switch — Unity; gain with 50% peaking;
and gain with 100% peaking. Unity sets the output level
equivalent to the input, with no added peaking.
If the cable between the interface and the display device
is shorter than 125 feet, and the Gain/Peak switch is set
to a value other than Unity, image overcompensation
can occur. If the edges of the image seem to exceed their
boundaries, or if thin lines and sharp edges look thick
and fuzzy, adjust the Gain/Peak switch setting.
10 DIP switches — 4 switches to control sync on green on output,
Digital Display Sync Processing, and serration pulses. The
fourth DIP switch is a spare (see "Setting the DIP switches" in
this chapter).
DDSP disables horizontal shift.
12 Output 1 and Output 2 — 6 BNC connectors each to output
RGsB, RGBS, and RGBHV. There is only one output on the
RGB 160xi
13 Stereo audio output — 3.5 mm captive screw audio connector.
SOG DDSP SERR SP
ARE
100-240 0.5A MAX.
50/60 Hz
OUTPUT
R
H
G
V
B
S
UNITY
50%
100%
GAIN/
PEAK
13 11 10 9 8
11