Extron Electronics RGB 160 - Manual (Page 5)

RGB 160xi and RGB 164xi • Introduction
Introduction
About this Manual
This manual documents two universal interfaces: RGB 160xi and
RGB 164xi. Unless otherwise specified, any references to “the
interface” refers to the features or operation of both interfaces.
About the Interfaces
The RGB 160xi and 164xi are universal interfaces with a video
bandwidth of 300 MHz and a horizontal frequency range of
15-160 kHz.
Features
2-color power/signal LED — When the interface is on, the
power/signal LED lights amber. When the interface is on
and a signal is present, the LED lights green.
Gain/peak control — Increases signal voltages to compensate for
signal degradation caused by long cable lengths.
Stereo audio — Front panel audio input and a 3.5 mm captive
screw output connector on the rear panel.
Horizontal shift — The picture can be shifted horizontally. A
min/max LED indicator lights red whenever the shifting
reaches its lower or upper limits.
ADSP™ (Advanced Digital Sync Processing) — Allows sync
processing operations, such as horizontal centering, to
occur without affecting the signal’s sync timing. This
allows horizontal centering to be applied to signals
that are output to digital display devices, such as LCD
projectors, DLP (digital light processor) projectors, and
plasma displays.
Dual outputs (RGB 164xi only) — Provides two identical
interfaced outputs.
Buffered local monitor outputs — Provides a buffered local
monitor output.
Under/through desk mounting — The interfaces can be
mounted either under or through a desk, or other suitable
surface, using the optional mounting kit.
Rack mounting (RGB 164xi only) — The RGB 164xi can be
mounted on a standard 1U Universal rack shelf.
1-2
RGB 160xi and RGB 164xi
2
Chapter Two
Controls and Installation
Front Panel Features
Rear Panel Features
Installation