Rosen Aviation 0602 Series : Single-Disc Blu-ray Player with SDI - Manual (Page 16)

Rosen Aviation Blu-ray DVD Player with SDI
Document Number: 105880 Revision: B
Date: 09/19/13
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 16 of 33
3. Re-insert the DVD to play and press ENTER for Ok.
The unit allows an unlimited number of Blu-ray region changes (A, B, or C) without
affecting the DVD region or remaining number of region changes on the player. To
change the Blu-ray region, use a universal remote control or an RS-232 or RS-485
controller. After you change Blu-ray regions with the remote, a notice screen, similar to
the one below, will display.
Figure 8 Message after changing a Blu-ray region
6. INITIAL POWER UP
Make sure that power is turned off and connect the following harnesses to the Blu-ray DVD player
connectors:
1. Ensure a secure ground connection on the Blu- ray DVD player’s grounding port
(uses a #10- 32 3/8” screw).
2. Connect 28VDC power to P2.
3. Attach the video to P3 and/or to P4.
4. Connect the available video inputs.
5. Adjust the fixed-level audio.
6. Apply power and wait for the LED lights to become active and the OSD main menu to
display on a cabin monitor. The default settings at power-up vary by RMEB model.
Do not plug or unplug the display connector while power is
applied.
When cycling power, leave unit off for 20 seconds before restoring
power.