Rosen Aviation 0603 Series : Rosenview MX - Manual (Page 17)

Rosen Aviation RosenView MX
Document Number: 106284 Revision: A
Date: 12/18/13
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 17 of 20
Screen is black 
Verify that the display is receiving power.

Verify that the pinout is correct.

Verify that the video source is on.

Verify all connections between the source and the display.

Ensure the internal system temperature is not above or below the
allowed parameters.
Image flickers

Verify that the signal cable is secure.

Verify that the vertical frame frequency is 75 Hz or less.
Image is distorted 
Verify pinouts.

Verify that a signal is reaching the display using an oscilloscope or
another display.

Examine the display for pinched or damaged cables.
GPS and ARINC LEDs
are blinking on and off 
The unit is not receiving data or there is a connection/wiring error.
7.2. RTCA DO-160 Qualification
The table below shows the DO-160 compliance of the RosenView MX. All testing is to DO-160
Rev E, except as noted. Omitted categories are not applicable to this product or its expected
installation.
Table 6 DO-160 Level E & F test criteria
Description Section Category Comments
Temperature and Altitude 4
Ground Survival/Short-Time Operating Low
Temp
4.5.1 A1
Operating Low Temperature 4.5.2 A1
Ground Survival/Short-Time Operating High
Temp
4.5.3 A1
Operating High Temperature 4.5.4 A1
In-flight Loss of Cooling 4.5.5 – Not applicable
Altitude 4.6.1 A1
Decompression 4.6.2 A1 (50,000 ft.)
Overpressure 4.6.3 A1
Temperature Variation 5
Temperature Variation 5.3.1 C
Humidity 6
Humidity 6.3.1 A