Rosen Aviation 0603 Series : Rosenview MX - Manual (Page 16)

Rosen Aviation RosenView MX
Document Number: 106284 Revision: A
Date: 12/18/13
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 16 of 20
If the GPS and ARINC LEDs are alternately blinking on and off,
then the unit is not receiving data or there is a connection/wiring
error.
7. TECHNICAL REFERENCES AND SUPPORT
Always check the RosenView MX product web page to ensure
that you are working with the most current revision of technical
documentation.
Table 4 Technical references
Product Part Number Location
Optional External Briefing Controllers 0300-410, 0300-411,
and 0300-412
H U
www.rosenaviation.com
UH
RosenView System 7-Button Controller 0300-407
H U
www.rosenaviation.com
UH
RosenView MX Outline and Installation Drawing 0603-003-CD
U
www.rosenaviation.com
UH
RS-485 Network Message Definitions 9002933 Contact Rosen Customer Support
Universal Color Remote Control Contact Rosen Sales for part number availability
HH
7.1. Troubleshooting
If the display does not function properly, refer to the following troubleshooting table for
symptoms and possible solutions before contacting Rosen Customer Support
Note: Always use an oscilloscope to verify the video signal. Always use a multimeter to verify
voltages. Check actual results against the requirements described in this manual.
Table 5 Troubleshooting tips and solutions
Problem Possible Solutions
No destination data

Enabled once the pilot inputs the flight data.
Data is missing

Verify the label is available on the ARINC bus. It is possible to hook up
two different ARINC buses. Note: Certain data points do not show up on
the GPS/RS-232 bus.
No video

Verify that a signal is reaching the display using an oscilloscope or
another display.

Verify that the display is turned on.

Verify that the pinout is correct.