Emerson Radio RET66BK - Manual (Page 16)

15
Programmed Playback
Use the Programmed Playback feature to play up to 20 tracks on a disc in any
desired order. You may also program a particular track to play several times within
a programmed sequence if desired.
Note: You cannot program a disc while it is playing. Press the STOP button
to stop playback and then follow the programming steps below.
1.) Load your disc as usual and wait until the display shows
the total number of tracks on the disc.
2.) Press the PROGRAM button on the front panel. The
PROG indicator begins flashing and “P 01” appears in
the display, indicating that you may enter the first track
in program memory #01.
3.) Press the F-SKIP or R-SKIP buttons to select
the first track number to be programmed.
Example: Track number 07.
When the desired track number appears in the display
press the PROGRAM button again. Track 07 is now
entered in Program Memory number “P 01”. The
program memory number now advances to number “P 02” and the PROG
indicator continues flashing.
Note: After pressing the PROGRAM button you must select a track number
and press the PROGRAM button again while the PROG indicator is still
flashing (within 10 seconds). After 10 seconds the PROG indicator goes
‘Off’ and you cannot enter a track in the memory. If this occurs, press the
PROGRAM button again to start the PROG indicator flashing and enter a
track in the memory within 10 seconds.
RET66_080504.p65 5/8/2004, 16:05 15