beautypg.com

To configure dsa800 series spectrum analyzer – RIGOL DSA875 User Manual

Page 2

background image

To Configure DSA800 Series Spectrum Analyzer

The basic characteristics of DSA800 include:
 1.5 GHz/3.2 GHz/7.5 GHz maximum frequency
 1.5 GHz tracking generator (DSA815-TG)/3.2 GHz tracking generator (DSA832-TG)/7.5 GHz tracking

generator (DSA875-TG)

 Various interface configurations: LAN, USB Host, USB Device and GPIB (optional)
 8 inch high-resolution (800×480 pixels) display; clear and easy-to-operate graphical interface
 Compact and portable design

You can select the desired options and optional accessories to configure DSA800 according to your need. The

procedures are as follows.

1. Select the instrument model according to the frequency range

Explanation

Order No.

Other Information

Without TG With TG

[1]

Spectrum Analyzer, 9 kHz to 1.5

GHz

DSA815

DSA815-TG

Provide standard accessories: Quick

Guide, CDROM (User’s Guide and

Programming Guide) and power cord.

Spectrum Analyzer, 9 kHz to 3.2

GHz

DSA832

DSA832-TG

Spectrum Analyzer, 9 kHz to 7.5

GHz

DSA875

DSA875-TG

2. Add other measurement functions

Explanation

Order No.

Other Information

Preamplifier, 100 kHz to 3.2 GHz

[2]

(only for DSA832)

PA-DSA832

When the signal under test is small,

turning on the preamplifier can reduce the

displayed average noise level so as to

measure even smaller signals.

Preamplifier, 100 kHz to 7.5 GHz

[2]

(only for DSA875)

PA-DSA875

Advanced Measurement Kit

[2]

AMK-DSA800

Provide various advanced measurement

functions: time domain power, adjacent

channel power, channel power, occupied

bandwidth, emission bandwidth,

carrier/noise ratio, harmonic distortion

and TOI.

3. Perform EMI pre-compliance test

Explanation

Order No.

Other Information

EMI Filter & Quasi-peak Detector

Kit

[2]

EMI-DSA800

Used for EMI pre-compliance test.

EMI Test System Software

EMI Test System

Note:

[1] If the tracking generator function is required, please order DSA815-TG/DSA832-TG/DSA875-TG spectrum analyzer (the

tracking generator is installed before the instrument leaves factory; return-to-factory installation is not supported).

[2] To install an option, acquire the option license according to the following procedures (first, order the desired option and the

option key is provided; then, log in

RIGOL website (www.rigol.com), click “Customer Center” and select “License Generate” to

enter the software license generation interface; finally, input the option key, instrument serial number (refer to the User’s Guide to

acquire the serial number) and identifying code as well as click “Generate” to acquire the corresponding option license); then,

please install the corresponding option by referring to

DSA800 Firmware and Option Installation Instruction

.

This manual is related to the following products: