Retrotec Spec-ENERGY STAR Requirements - Manual (Page 2)

ENERGY STAR 3.0 Recommended Results
Continuous results without calculations!
Two simple ways to program a gauge:
Duct leakage results
required in CFM
per 100 square feet
at 25 Pa.
House leakage is
displayed in air
changes per hour.
1.) Order one pre-set to meet ENERGY STAR 3.0 standards.
● Gauges can be programmed at the factory to display
only ENERGY STAR 3.0 results.
● Remove the rest: see only the devices you want!
25
Pa
10
cfm/
100ft 2
area: 1000.0 ft 2
-25
Pa
3.5
/h
area: 1000.0 ft 2
Results are displayed immediately
with no calculations!
Figure 1: duct test results
Figure 2: home leakage results
Set up the gauge to meet ENERGY STAR 3.0 standards
quickly and easily.
● Read results directly off the gauge.
Trainers: Demonstrate a complete test in just five minutes.
● Easy to understand for your trainees: the gauge does it
all for them!
2.) Re-program your own gauge in minutes!
● Use easy-to-follow QuickGuides, or
● Just watch the video!
Set up takes
less than a minute
and the gauge will always
remember your settings!