Precision Flight Serial CAT II and Microsoft Flight Simulator 9 (2004) - Manual (Page 3)

CAT 2 System and FS2004 Set Up Guide 3 | P a g e
A. Changing the Protocol
If your Cirrus II has this switch, this will give your whole system the capability to use it with FS2004 and
FS2004.
If your Cirrus II console does not have the protocol switch your whole system will not work with any version
of Microsoft Flight Simulator software.
If your Cirrus II is equipped, changing the position of this switch allows you to change the output data of
your Cirrus II to a data that FS2004 and FS2004 will understand.
This is a picture of the PFC THROTTLE QUADRANT CONSOLE but the location of the switch is the same,
behind the throttle quadrant lever.
To remove throttle quadrant you must:
1. Pull all the levers down (towards you). This will release the pressure from the push rods
2. Loosen the thumb screw by turning it counter clockwise