Ab c d – Meliconi Gumbody Facile 3 web User Manual

Page 4

To use this function, the remote control you wish to copy the function from must be working

learn

the missing functions from an original remote control and save them on the F1 - F2 - F3 -

F4 buttons or on a normal remote control, thereby replacing the command that was on the button

previously.
learn

all the functions from a new remote control not included in the universal remote control databank

because it was released on the market afterwards.

Using this function you can:

LEARN FUNCTION

UPDATING VIA AUDIO CABLE

Connect the remote control using the audio cable in the kit

supplied to a

PC with an internet connection. Connect the

cable as follows:

1. Open the remote control battery compartment.

2. Connect the fl at end of the cable (A) to the connector at

the three points

J1 under the battery housing (B), taking

care not to press too hard

(C).

3. Connect the jack at the other end of the cable (D) to the

PC audio output (or headphones output).

4. Follow the instructions in the on-line guide at www.meli-

coni.com/guide.

DISPLAY CODE IN USE

If they do not appear, repeat the procedure. If this still does not work it means the code indicated

is not in the remote control, so it must be loaded using the INTERNET as described in the following

section.

If you set up the remote control using the

MANUAL SE-

ARCH procedure, obtain and make a note of the code in use

as follows:

1. Press and hold down for 6 seconds the device selection

button corresponding to the device you wish to enter the

code for.

2. Release the button. The indicator light will fl ash. Press

the

TV / radio button for an instant.

3. After a pause of several seconds, the indicator light pro-

duces four sets of fl ashes, spaced out, corresponding to

the code to be obtained. Count the number of fl ashes.

Each set of fl ashes corresponds to one fi gure in the

code. Ten fl ashes correspond to the fi gure 0.

4. Make a note of the code obtained on the label on the in-

side of the battery cover. You may need it in future.

Code obtained =

1306

6 SEC.

This manual is related to the following products:

Gumbody Universal 5 web