Setting codes using a manual search, Entering the code directly – Meliconi Gumbody Facile 3 web User Manual
Page 3
10
NOTE: If you don’t receive an SMS on your cell phone or if the message says ERROR / NO CODE, it
means the system has not been able to process the data you have sent. Do not try sending another SMS
use the
MANUAL SEARCH instead.
(only to be performed if the specifi c code could not be found)
SETTING CODES USING A MANUAL SEARCH
CHECK
Check that the other buttons correspond to the functions of the original remote control; if not, it is likely
that the code found is incorrect, but is used for a very similar device. In that case, repeat the procedure
from point 2.
If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN
USE procedure and make a note of it inside the battery cover.
NOTE: During the search the indicator stops fl ashing and the remote control exits the programming mode
in the following cases:
• if for 12 seconds the button indicated is not pressed or if another button is pressed
• if the list of codes to fi nd is terminated. If this happens, go to the www.meliconi.com/guide website.
ENTERING THE CODE DIRECTLY
(only to be performed if you know the specifi c code to be set)
1. Switch on the device to be programmed and select a pro-
gram
2. Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
3. Release the button. The indicator light will fl ash. Point the
remote control at the device and press the
ON/OFF key.
If the device does
NOT switch off press the same button
again slowly (it may be necessary to press the button se-
veral times).
4. When the device responds correctly, press OK. Three
long fl ashes indicate that the operation has been carried
out
correctly.
6 SEC.
or
1. Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
2. Release the button. The indicator light fl ashes. Imme-
diately enter the specifi c code previously found. (e.g.
1306).
3. Three long fl ashes indicate a correct setting.
6 SEC.
or
or
or