Meliconi Gumbody Facile 3 web - Manual (Page 2)

INSERTING THE BATTERIES
Before using the remote control, insert the batteries and programme it.
Do not leave fl at batteries inserted, as liquid may leak and damage the remote control
The Facile 3 web remote control is a universal remote, its memory containing data relating to many devices of
different brands available on the market.
Each original device has a specifi c code which must be used to set up the remote control.
Therefore, to use your Facile 3 web you must enter the specifi c code for each device you wish to control.
So use one of the following methods to identify the correct code and set it in your remote control:
A) - INTERNET (recommended)
B) - CELL PHONE (SMS)
C) - MANUAL SEARCH
SETTING CODES
Today, Meliconi gives customers who don’t have internet the chance to receive the codes for programming their
remote control directly on their cell phone.
Simply send an
SMS to this number 0039 345 7518893 as follows: 3A, Type, Brand, Model
- Type = indicate the device to be controlled using one of the following abbreviations: TV / SAT / TER (Digital
Terrestrial decoder).
- Brand, Model = to indicate the brand and the model of the device to be controlled.
Example: 3A, TV, PHILIPS, 32PFL3614 (if you don’t know the model, don’t write anything after the brand)
Once you have received the SMS with the list of codes, set the fi rst code in the remote control as described in
the
ENTERING THE CODE DIRECTLY section.
Stand in front of the device with the MELICONI remote control. Turn the device on and then press the ON/OFF
button on the remote.
If the device does
NOT switch off, try setting the consecutive code in the SMS list in the remote control.
When the device reacts check whether the other buttons are operating correctly too.
If they do, the remote control is ready to use.
If they don’t,
you are probably using an incorrect code destined for a very similar device; at this point
ignore the SMS list and consult the SETTING CODES USING A MANUAL CODE section to fi nd a more suitable
code.
The remote control requires 2 new 1.5V alkaline AAA/LR03 batteries.
Insert them as illustrated.
Try pressing a number button and check that the red light remains lit
continuously until you release the button. If the light fl ashes, the batteries
inserted are not charged and are about to go fl at, therefore you must
substitute them.
If you have an Internet connection available, follow the on-line guide on the www.meliconi.com/guide website
to identify the specifi c codes for the devices you wish to command. Then set the codes manually in your
MELICONI remote control as described in the ENTERING THE CODE DIRECTLY procedure.
(the service s fee and the only cost is that of sending the SMS, which naturally depends on the rates of the
service operator in question)
SETTING CODES USING A CELL PHONE
SETTING CODES USING INTERNET
9