Phase 5 - assembly of upper frame (element 4) – MCZ Picasso User Manual
Page 13

INSTALLATION AND USE MANUAL
Chapter 3
PICASSO
page
13
3
Technical service – all rights reserved by mcz spa
Reproduction prohibited
3.6. PHASE 5 - ASSEMBLY OF UPPER FRAME (element 4)
Set the upper frame (element 4) on the side frames, with which it must be perfectly flush. If you have not
already done so in phase 2, drill holes at the M6 threaded bars on the back of the upper frame and fasten
it
using the screws, nuts and washers provided. For greater safety, you should use two nuts for each threaded
bar (nut and locking nut).
Make sure that when assembly is complete, the cladding is adherent to the wall, squared off and level with the
counter-wall and floor.
ASSE RIVESTIMENTO=
ASSE TERMOCAMINO
180
700
180
1060
180
14
22
16
02
1060
=
=
MURO PERIMETRALE
DISTANZA DI
SICUREZZA
MURO PERIMETRALE
60
1060